Draw and discard pile holder – made-to-measure 3D print file

Vorschau wird erzeugt …

About this model

Draw and discard pile holder – Holder for up to four card piles side by side – draw pile, discard, exile or tokens. The trays fit card format, sleeves and pile height exactly, with finger notches at the sides and a label at the front.

In Fomio Studio you set up the model to your measurements in the browser, see it in 3D on the print bed right away and download it free as STL or 3MF for your slicer.

Common questions

The cards sit too tight in the tray.

In “Expert” raise the “room around the cards”. Double-sleeved cards need “sleeves: Double”.

What is the window in the floor for?

You push the pile up from below when only a few cards are left. It also saves filament. Switch it off in “Expert”.

Four piles do not fit the print bed.

With sleeves four TCG piles are wider than 256 mm. Print two holders with two piles each.